Emergency Procedures
130
bulb. The lighting system is a safety
component, please pay more attention
on the replacement of it and ensure that
any detail must be proper in case of
replacement. Get to the Chery’s special
service station to have it repaired, if
necessary.
The position lamp bulb can’t be
replaced. If the bulb fails to work,
please immediately get to the Chery’s
special service station to have it
repaired.
Front fog lamp bulb
Please get to the Chery’s special
service station to replace the front fog
lamp bulb.
Tail lamp bulb
1. Open the tail door, and unscrew
the two nuts (under the plate
guard) used to fix the tail lamp
from the internal side of luggage
boot in the anticlockwise
direction. Then, unscrew three
fixing bolts from the tail lamp in
the anticlockwise direction,
remove the harness connector
from the tail lamp, and take out
the tail lamp.
2. Unscrew the protecting hoods
from the bulb in the
anticlockwise direction according
to the position as shown in the
diagram.
3. Remove the harness connector
from the bulb, press downward
the clip of bulb holder by hand so
as to make the clip get through
the location groove and split
towards the both sides, take out
the bulb, and pay more attention
to the location mark of the bulb.
4. CAUTION：DO NOT touch the
surface of new bulb by hand in
Position Lamp Holder
Low Beam Holder
High Beam
Holder
Turn Signal
Lamp Holder
Turn Signal Lamp
To Next Page
Loading...
