Chevin S1500 - Output Power Specifications; Distortion, Frequency Response, Slew Rate

Technical Specifications
Output Power
1% THD, both channels driven
8 Ohm per channel
4 Ohm per channel
2,7 Ohm per channel
2 Ohm per channel
1% THD, one channel driven
8 Ohm per channel
4 Ohm per channel
2,7 Ohm per channel
2 Ohm per channel
Bridge mono
8 Ohm, 1% THD
4 Ohm, 1% THD
S1500
600W
1100W
-
1600W
625W
1150
-
1750W
2200W
3400W
S1504
800W
1320W
1500W
-
840W
1444W
1720W
-
2600W
-
S2000
700W
1173
-
1764W
730W
1260W
-
1922W
2300W
3500W
Distortion / 1kHz/THD %
< 0,02%
Frequency response
at 10 dB below nominal power
20 Hz – 20 kHz +0/-1dB
20 Hz – 50 kHz +0/-1dB
Subsonic filter
on / off
40 Hz / 80 Hz
Damping factor / 8 Ω / 1kHz
> 200
Slew rate / 8 Ω
20 V /
μs
Signal – noise ratio
20 Hz – 20 kHz below rated power
“A” weighted
- 103 dB
- 112 dB
Input sensitivity
full rated power / 8 Ω
1V
Input impedance
10 k Ω unbalanced
20 k Ω balanced
Controls
front panel: mains switch
gain controls (both channels)
rear panel: switches for mode selection
subsonic filter
GND lift on or off
LED Indicators
yellow BRIDGE, red PROTECT,
yellow LIMIT IN and LIMIT OUT
green SIGNAL, blue ON
Connectors
Input: balanced XLR
Output: Neutrik Speakon
Cooling
step-switched fan
Air flow: front to back
Protection
short circuit, thermal, load-mismatch, DC
Output circuit type
Class H
Dimensions (mm)
W x H x D = 483 x 88 x 387 (2U)
Weight
12 kg
Power
AC 220 – 240V ~ 50 – 60 Hz
Max power consumption (230V ~)
3680VA
This manual is intended for informational purposes only. All details included herein are subject to change without notice.
Chevin Research shall not be held responible for any damages, direct or indirect, arising from or relating to the use of this
manual.
© Chevin Research 2008. All rights reserved.
11 12