230 Vehicle care
1. Disengage wheel cover with a
screwdriver and remove.
2. Fold out the wheel wrench and
install ensuring that it locates
securely and loosen each wheel
nut by half a turn.
3. Rotate the jack handle to raise the
lift head slightly and place the jack
vertically at the position marked
with half circle.
4. Attach jack handle to the jack and
attach wrench to the jack handle
correctly.
Then raise the jack to join the lift
head at the jacking position firmly.
5. Rotate the wrench checking the
correct position of jack until wheel
is clear of the ground.
6. Unscrew the wheel nuts.
7. Change the wheel.
8. Screw on the wheel nuts.
9. Lower vehicle.
10. Install the wheel wrench ensuring
that it locates securely and tighten
each nut in a crosswise
sequence.
11. Align the valve hole in the wheel
cover with the tyre valve before
installing.
Install wheel nut caps.
To Next Page
Loading...
