Instruments and controls 77
It illuminates when clutch pedal
needs to be operated to restart the
engine.
See Automatic engine start/stop
feature 3 163.
Antilock brake system
(ABS)
u illuminates yellow.
Illuminates for a few seconds after the
ignition is switched on. The system is
ready for operation when the control
indicator goes out.
If the control indicator does not go out
after a few seconds, or if it illuminates
while driving, there is a fault in the
ABS. The brake system remains
operational but without ABS
regulation.
Antilock brake system 3 173.
Upshift
[ illuminates when upshifting is
recommended for fuel saving
reasons.
Manual transmission 3 171.
Power steering
c illuminates yellow.
It illuminates when the ignition is
switched on and goes out shortly after
the engine starts.
If the indicator does not go out after a
few seconds, or if it illuminates while
driving, there is a fault in the power
steering.
Seek the assistance of a workshop.
Ultrasonic parking assist
r illuminates yellow.
■ Fault due to sensors that are dirty
■ Covered by ice or snow
■ Outside ultrasonic waves
interference
Once the source of interference is
removed, the system will operate
normally.
If the control indicator does not go out,
have the cause of the fault in the
system remedied by a workshop.
Ultrasonic parking sensors 3 178.
Electronic Stability Control
b illuminates or flashes yellow.
Illuminates
A fault in the system is present.
Continued driving is possible. Driving
stability, however, may deteriorate
depending on road surface
conditions.
Have the cause of the fault remedied
by a workshop.
Flashes
The system is actively engaged.
Engine output may be reduced and
the vehicle may be braked
automatically to a small degree.
Electronic Stability Control 3 175.
Electronic Stability Control
off
a illuminates yellow.
Illuminates when the system is
deactivated.
To Next Page
Loading...
