Chevrolet Bolt EV Owner Manual (GMNA-Localizing-U.S./Canada-
14637856) - 2021 - CRC - 10/2/20
108 Lighting
Turning On and Enabling IntelliBeam
To enable the IntelliBeam system, press
b on the turn signal lever when the
exterior lamp control is in the AUTO or
5
position.
Driving with IntelliBeam
The system only activates the high beams
when driving over 40 km/h (25 mph).
The blue high-beam on light appears on the
instrument cluster when the high beams
are on.
There is a sensor near the top center of the
windshield that automatically controls the
system.
Keep this area of the windshield clear of
debris to allow for best system performance.
The high-beam headlamps remain on, under
the automatic control, until one of the
following situations occurs:
.
The system detects an approaching
vehicle’s headlamps.
.
The system detects a preceding vehicle’s
taillamps.
.
The outside light is bright enough that
high-beam headlamps are not required.
.
The vehicle's speed drops below 20 km/h
(12 mph).
.
The IntelliBeam system is disabled by the
button on the turn signal lever. If this
happens, press
b on the turn signal
lever when the exterior lamp control is in
the AUTO or
5 position.
The instrument cluster light will come on
to indicate the IntelliBeam system is
reactivated.
The high beams may not turn off
automatically if the system cannot detect
another vehicle's lamps because of any of
the following:
.
The other vehicle’s lamps are missing,
damaged, obstructed from view,
or otherwise undetected.
.
The other vehicle‘s lamps are covered
with dirt, snow, and/or road spray.
.
The other vehicle’s lamps cannot be
detected due to dense exhaust, smoke,
fog, snow, road spray, mist, or other
airborne obstructions.
.
The vehicle's windshield is dirty, cracked,
or obstructed by something that blocks
the view of the light sensor.
.
The vehicle is loaded such that the front
end points upward, causing the light
sensor to aim high and not detect
headlamps and taillamps.
.
Driving on winding or hilly roads.
The IntelliBeam system may need to be
disabled if any of the above conditions exist.
Exterior Lamps Off Reminder
A warning chime sounds if the driver door is
opened while the vehicle is off and the
exterior lamps are on.
Headlamp High/Low-Beam
Changer
Push the turn signal lever away from you
and release, to turn the high beams on. To
return to low beams, push the lever again
or pull it toward you and release.
To Next Page
Loading...
