Instrument and control device 69
alarm light is on, the mileage will show
"Please Refuel".
Press the "OK" button under the
current interface, the driving time will
be cleared, but the mileage can not be
cleared.
Interface 5 - tire pressure indication
The tire pressure detection system
(TPMS) can display the tire pressure
and tire temperature corresponding to
the four tires of the current vehicle.
Tire pressure meter displays accuracy
is 0.1 bar. When the tire shows a
pressure below the standard pressure
value or the alarm flashes, please
inflate or check the tire in time. The
standard pressure of the tire is
described in the section "Technical
data".
When the tire temperature is too high,
such as long slope and frequent braking,
please stop as soon as possible to cool.
When tire pressure failure, need to
timely shop repair and inspection of tire
conditions.
Need to maintain tire pressure in
standard specification, otherwise it
will affect the tire life and vehicle
handling performance, or cause
puncture
Danger.
If the tire temperature is too high
please do not continue to drive.
The brake may not be able to
provide sufficient braking force
due to overheating, the tire may
also be overheated, and stop as
soon as possible to wait for cooling
and check.
Vehicle Information Setting Tab
Under this tab, you can troubleshoot
fault information, fatigue driving
settings, and display language
settings and rear seatbelt unbuckled
warning setting
Toggle the up / down selection key
and press "OK" to enter the interface
under this tab.
When the display pops up the text
alarm message, the steering wheel
control key will be blocked, then press
the button will temporarily no
response until the text alarm message
disappears.
To Next Page
Loading...
Need help?
General
