4. With the coolant surge tank pressure cap off,
start the engine and let it run until you can
feel the upper radiator hose getting hot. Watch
out for the engine cooling fan.
By this time, the coolant level inside the
coolant surge tank may be lower. If the level is
lower, add more of the proper mixture to the
coolant surge tank until the level stabilizes
at the FULL COLD mark on the coolant
surge tank.
5. Then replace the pressure cap. Be sure the
pressure cap is hand-tight and fully seated.
Check the level in the surge tank when
the system has cooled down. If the coolant is
not at the proper level, repeat Steps 1
through 4, then reinstall the pressure cap. If
the coolant is not at the proper level when the
system cools down again, see your dealer.
Power Steering Fluid
See Engine
Compartment Overview
on page 328 for
reservoir location.
357
To Next Page
Loading...
