Chevrolet Spark Lite - Chassis

Service and Maintenance
. . . 214
Drivetrain (continued)
Clutch
Type.............................................................Single Dry Plate ................................... Single Dry Plate
Outside Diameter ....................................................180 mm .............................................. 184 mm
Inside Diameter .......................................................125 mm ........................................... 127.5 mm
Thickness..................................................................7.2 mm ............................................. 7.65 mm
4-Speed Automatic Transmission (0.8 SOHC Engine)
Drive System ............................................................................................................Front Wheel Drive
Gear Ratios
First ..........................................................................................................................................2.914
Second .....................................................................................................................................1.525
Third ........................................................................................................................................1.000
Fourth ......................................................................................................................................0.725
Reverse.....................................................................................................................................2.642
Final Drive Ratio .......................................................................................................................4.709
09Spark_GenR.fm Page 214 Monday, May 5, 2008 2:03 PM
215 . . .
–
–
–
–
Section 4
Chassis
Front Suspension........................................................................................................McPherson Strut
Rear Suspension ......................................................................................................Torsion Beam Axle
Alignment (Unloaded)
Front Camber......................................................................................................................30’ ± 45’
Rear Camber .................................................................................................................. -1°30’ ± 30’
Caster.............................................................................................................................. 3°48’ ± 60’
Front Toe-In ........................................................................................................................10’ ± 10’
Rear Toe-In..........................................................................................................................15’ ± 20’
Steering
Type............................................................................................................................ Rack & Pinion
Overall Gear Ratio
Manual Steering.................................................................................................................21.1 : 1
Power Steering.................................................................................................................16.45 : 1
Steering Wheel Diameter..................................................................................................... 370 mm
Minimum Turning Radius ........................................................................................................ 4.6 m
09Spark_GenR.fm Page 215 Monday, May 5, 2008 2:03 PM