Chicago Electric 45949 - Maintenance; Main Parts List

Page 9SKU 45949
Maintenance
Warning: Before performing any maintenance you must disconnect power to the Plasma
Cutter and discharge it’s electrode to ground.
1. Regularly clean the Control Filter Receptacle on the rear panel.
2. Clean or replace the nozzle and electrode when they become dirty or worn.
3. Store the Plasma Cutter in a clean and dry location.
Main Parts List
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
NOTE: Some parts are listed and shown
for illustration purposes only and are not
available individually as replacement
parts.
All manuals and user guides at all-guides.com