Page 4 For technical questions, please call 1-800-444-3353. SKU 95136
protection must be used for appropriate
conditions.
Tool Use and Care
Use clamps (not included) or other 1.
practical ways to secure and support
the workpiece to a stable platform.
Holding the work piece by hand or
against your body is unstable and may
lead to loss of control.
Do not force the tool. Use the correct 2.
tool for your application. The correct
tool will do the job better and safer at the
rate for which it is designed.
Do not use the power tool if the Power 3.
Switch does not turn it on or off. Any
tool that cannot be controlled with the
Power Switch is dangerous and must be
replaced.
Disconnect the Power Cord Plug from 4.
the power source before making any
adjustments, changing accessories,
or storing the tool. Such preventive
safety measures reduce the risk of
starting the tool accidentally.
Store idle tools out of reach of 5.
children and other untrained persons.
Tools are dangerous in the hands of
untrained users.
Maintain tools with care. Keep cutting 6.
tools maintained and clean. Properly
maintained tools are less likely to bind
and are easier to control. Do not use a
damaged tool. Tag damaged tools “Do
not use” until repaired.
Check for misalignment or binding of 7.
moving parts, breakage of parts, and
any other condition that may affect
the tool’s operation. If damaged,
have the tool serviced before using.
Many accidents are caused by poorly
maintained tools.
Use only accessories that are 8.
recommended by the manufacturer
for your model. Accessories that may
be suitable for one tool may become
hazardous when used on another tool.
Service
Tool service must be performed only 1.
by qualied repair personnel. Service
personnel could result in a risk of injury.
When servicing a tool, use only 2.
identical replacement parts. Use of
unauthorized parts or failure to follow
maintenance instructions may create a
risk of electric shock or injury.
SPECIFIC SAFETY RULES
Maintain labels and nameplates on the 1.
tool. These carry important information.
If unreadable or missing, contact Harbor
Freight Tools for a replacement.
Always wear ANSI approved safety 2.
impact eye goggles and heavy work
gloves when using the tool. Using
personal safety devices reduce the risk
for injury. Safety impact eye goggles and
heavy work gloves are available from
Harbor Freight Tools.
Maintain a safe working environment. 3.
Keep the work area well lit. Make
sure there is adequate surrounding
workspace. Always keep the work area
free of obstructions, grease, oil, trash,
and other debris. Do not use a power
dusts, and vapors. Do not use this
product in a damp or wet location.
Avoid unintentional starting. 4. Make
sure you are prepared to begin work
before turning on the tool.
To Next Page
Loading...
