To Next PageTo Next PageWhy does my Chicago Electric Saw operate sporadically?
If your Chicago Electric Saw runs sporadically or at low power, examine the power supply and power cords to ensure they are adequate. Also, inspect the carbon brushes for wear or cracks; replace them if they are damaged.
What to do if material frays when using Chicago Electric ITEM 69684?
If the material frays or chips when using your Chicago Electric Saw, make sure the finished side of the material is facing up. Check the blade for damage and sharpen or replace it if needed. Ensure the blade is appropriate for the material you are cutting. Use a thin piece of scrap material underneath or behind the material to support the edges.
Why does the blade bind on my Chicago Electric Saw?
If the blade binds, slowing down or stopping your Chicago Electric Saw, ensure the material is flat on the table, flush against the fence, and supported on both ends. Also, check the condition of the material and ensure the blade is compatible with the material you're cutting.
How to prevent wood burning when cutting with a Chicago Electric ITEM 69684 Saw?
If wood burns at the ends when cut with your Chicago Electric Saw, clean the blade using blade cleaner or mineral spirits. Also, check the position of the work material on the table, ensuring it is flat, flush against the fence, and supported on the ends.
What to do if Chicago Electric Saw blade doesn't cut through?
If the blade of your Chicago Electric Saw does not cut completely through the workpiece, check if the Depth Stop setting is engaged and disengage it by moving it to the right. If the Depth Stop is set too shallow, adjust the Depth Stop Bolt for the desired cutting depth.
General| Type | Circular Saw |
|---|---|
| Blade Size | 7-1/4 inches |
| Arbor Size | 5/8 inches |
| Voltage | 120V |
| Amperage | 15 A |
Essential safety precautions and guidelines for operating the power tool safely.
Detailed procedure for safely removing and installing a new saw blade.
Steps to ensure the fence is accurately positioned for precise cuts.
