Chicago Electric 14 Industrial Cut-off Saw 68104 User Manual (English)

Questions and Answers:

T
tiffany16Jul 31, 2025
What to do if my Chicago Electric 14 Industrial Cut-off 68104 Saw will not start?
- E
  Eric LopezJul 31, 2025
  There are several potential reasons why your Chicago Electric Saw won't start: * The power cord may not be properly connected; ensure it is securely plugged in. * The outlet you're using might not be providing power; check the outlet and the circuit breaker. If the breaker is tripped, ensure the circuit meets the tool's capacity and isn't overloaded. * The tool's thermal reset breaker may have tripped; turn off the saw, let it cool down, and then press the reset button on the tool. * There may be internal damage or wear; in this case, have a qualified technician service the saw.
K
katie43Aug 6, 2025
Why is my Chicago Electric 14 Industrial Cut-off 68104 Saw overheating?
- W
  William MayoAug 6, 2025
  Overheating in your Chicago Electric Saw can occur due to several reasons: 1. You might be forcing the machine to work too fast; allow it to operate at its own pace. 2. The motor housing vents could be blocked; use compressed air to blow out any dust, while wearing ANSI-approved safety goggles and a NIOSH-approved dust mask/respirator. 3. A long or small diameter extension cord may be straining the motor; try eliminating the extension cord, or use one with the correct diameter for its length and load.
K
Keith NelsonAug 12, 2025
Why is my Chicago Electric 14 Industrial Cut-off 68104 operating slowly?
- O
  owendanielAug 12, 2025
  If your Chicago Electric Saw operates slowly, the extension cord may be too long or the wire size may be too small. Try eliminating the extension cord. If you need to use an extension cord, make sure it has the correct diameter for its length and the load.
M
Martin CordovaAug 18, 2025
What causes excessive noise in Chicago Electric Saw?
- C
  Cathy McneilAug 18, 2025
  Excessive noise or rattling in your Chicago Electric Saw is likely due to internal damage or wear, such as to the carbon brushes or bearings. In this case, have a technician service the tool.
Y
yvonnebradleyAug 25, 2025
Why is the performance of my Chicago Electric 14 Industrial Cut-off 68104 decreasing over time?
- S
  Samuel KellyAug 25, 2025
  Decreased performance in your Chicago Electric Saw over time can be due to: 1. Worn Cut-off Wheels: Replace them as needed. 2. Worn or damaged carbon brushes: Have a qualified technician replace the brushes.