25
Fault Cause Solution
Power indicator LED (5)
on the child unit (with
image and sound trans-
mitter function) / par-
ent unit (with image and
sound receiver function)
is OFF;
- Child unit (with image and sound
transmitter function) and/or parent
unit (with image and sound receiver
function) are switched OFF.
- The alkaline batteries on the child
unit and/or the rechargeable battery
pack on the parent unit are dead.
- The mains adaptors on the child
unit / parent unit are disconnected or
connected incorrectly.
- No power supply
- Music mode enabled on the child
unit (with image and sound trans-
mitter function) with min volume
setting.
- Switch on the child unit (with im-
age and sound transmitter function)
and/or parent unit (with image and
sound receiver function)
- Replace the alkaline batteries on
the child unit (with image and sound
transmitter function) and/or the
rechargeable battery pack on the
parent unit (with image and sound
receiver function).
- If the units are powered using the
mains adaptors, check that these are
connected correctly to the mains
sockets
- Check that the socket has power
supply.
- Press the ON/OFF button (2) on
the child unit (with image and sound
transmitter function) to enable Baby
Control mode or increase the volume
using buttons 9a/9b (VOL+, VOL-) to
continue operating in Music mode.
There is no sound from
the parent unit (with
image and sound receiv-
er function)
- No sound is picked up by the child
unit (with image and sound trans-
mitter function);
- The voice activation mode has been
selected
- The volume on the parent unit (with
image and sound receiver function)
is set too low;
- The alkaline batteries on the
child unit (with image and sound
transmitter function) and/or the
rechargeable battery pack on the
parent unit (with image and sound
receiver function) are dead.
- The parent unit (with image and
sound receiver function) could be
switched off.
- As soon as any noise/sound is
picked up by the transmitter, the
child unit (with image and sound re-
ceiver function) will be activated. In
any case, to make sure it works, asks
someone to speak into the trans-
mitter in the child’s room to make
sure you are receiving properly.
- Check the operating mode settings
if the
icon is visible on the
BACKLIT LCD display (8) and the
screen is black, the voice activation
mode has been selected.
- Press the volume button to maxi-
mum level (3) +
- on the
parent unit (with image and sound
receiver function) until you hear
sounds/noise.
- Replace the alkaline batteries on the
child unit (with image and sound
transmitter function) and/or the
rechargeable battery pack on the
parent unit (with image and sound
receiver function).
- Turn the parent unit (with image
and sound receiver function) ON
Interference - HOPPING technology guarantees
protection against interference
caused by similar devices, however
on rare occasions interference can
be caused by the presence of an-
other similar device transmitting in
the immediate vicinity.
- Electromagnetic pollution (vicinity
to transmitting radio aerials, high
voltage cables etc).
Move the device away from similar
devices and/or move away from this
position.
TROUBLESHOOTING
If any problems occur, please check that:
- Both units are switched on.
- Both units are correctly connected to the mains adaptor (1), plugged into the power socket, or that the alka-
line batteries and rechargeable battery pack are fully charged.
To Next Page
Loading...
