Chicco 06654 - Technical Features

26
Decrease in operating
range
- Presence of obstacles, metal struc-
tures, reinforced concrete walls etc.
between the child unit (with image
and sound transmitter function)
and the parent unit (with image and
sound receiver function).
- The alkaline batteries on the
child unit (with image and sound
transmitter function) and/or the
rechargeable battery pack on the
parent unit (with image and sound
receiver function) are dead.
- Bring the units closer together
or reposition them to reduce the
number of obstacles, metal struc-
tures, reinforced concrete walls etc.
between them.
- Replace the alkaline batteries on the
child unit (with image and sound
transmitter function) and/or the
rechargeable battery pack on the
parent unit (with image and sound
receiver function).
Electrostatic or electro-
magnetic noise
- Electrostatic or electromagnetic
interference due to electrostatic
or electromagnetic fi elds emitted
by other electrical appliances: e.g.
white goods, mobile or cordless
phones etc.
- Identify and, where possible, re-
move the source of interference.
Presence of hissing or
whistling
- The units are too close together
- The volume setting on the parent
unit (with image and sound receiver
function) is too high.
- Move the units further apart;
- Turn down the volume on the par-
ent unit (with image and sound re-
ceiver function).
The parent unit (with im-
age and sound receiver
function) emits very low
volume sound.
- The child is too far away from the
child unit (with image and sound
transmitter function)
- The volume setting on the parent
unit (with image and sound receiver
function) is too low.
- Move the child unit (with image
and sound transmitter function) 1-2
metres away from the baby.
- Turn up the volume on the parent
unit (with image and sound receiver
function).
TECHNICAL FEATURES
Child Unit (with image and sound transmitter
function)
Mod. 06654
Power supply:
- Internal: ALKALINE BATTERIES 4 X 1.5V AA/LR6
TYPE
- External: Mains Adaptor (9V
, 600mA )
Transmission
- Transmission frequency channel: 2400 MHz -
2454MHz
- Transmission output: 100mW max
The child unit (with image and sound transmission
function) video-camera LEDs emit infrared rays
that do not exceed the Class I LEA required by EN
Standard 60825-1.
Parent Unit (with image and sound receiver
function)
Mod. 06654
Power:
- Internal: RECHARGEABLE BATTERY PACK 4 X 1.2V,
1500 mAh, AA TYPE
- External: using the recharger slot on the special
holder base connected to the mains adaptor:
(9V
, 600mA )
Reception:
- Reception frequency channel: 2400 MHz -
2454MHz
- Reception output: 100mW max
Mains Adaptor
Type: auto-switching mains adaptor with dual in-
sulation
Power: 100-240V~, 50/60Hz
Output voltage and current: 9.0V
, 600mA
Power output: 5.4 mA max
Plug pole
whom you purchased your appliance.
SYMBOLS KEY
single phase alternate current
direct current
for indoor use only
class II device - dual insulation
complies to relative CE
directives and subsequent
amendments
WARNING!
User instructions
Please read the enclosed instructions