WARNING: Avoid serious injury or death to your child. You must
read and understand the Corso Flex Modular Seat Feature instructions
and the instructions in the User Guide. If you do not understand these
instructions, STOP and call Chicco at 1-877-424-4226.
INSTRUCTIONS: Corso® Flex Modular Seat
IMPORTANT: Please also refer to the instructions that came with your product.
SS0039E_02
Prepare Modular Seat for attachment to Stroller
Frame. Make sure the hub posts are both in the same
position, as shown. If not, squeeze the recline handle with
one hand and rotate the hub post with the other.
1
Open the Seat Frame.
2
Line up and insert the attachment hubs on both sides of the Seat Frame
into the attachment slots on the Stroller Frame, as shown. Pull up on the Seat
Frame to make sure it is securely attached to the Stroller Frame.
3
“CLICK!”
3
2
1
WARNING
This stroller features three harness positions. Always use a harness
position located ABOVE the child's shoulder line. If multiple harness
positions are above the child's shoulder line, use the one closest to it.
Seat Front
Release the hook and loop material at the top of the seat back to expose
the seat board. Slide the D-ring through opening on the seat back. Then pull
through the opening on the seat pad. Re-insert the D-ring into the correct height
position, and repeat for the other side.
Always use the same height position for both straps. Depending on Shoulder
Harness height position, D-ring may be located below visible opening in
seat back.
6
To adjust the Shoulder Harness to another height
position, locate the D-ring on the back of the seat as
shown.
5
The Shoulder Straps can be adjusted to 3 height
positions as shown.
4
To Next Page
Need help?
General
