Chicco KeyFit 35 - Head Rest and Harness Strap Removal; Head Rest Fabric Removal; Seat Back Fabric Removal; Re-attaching Softgoods

2 3
At the top and side of the Carrier, flip the plastic tabs
out from under the lip of the Carrier. Pull the fabric from
the top and sides of the Carrier.
9
Pull forward on the Seat Back fabric and guide the Head Rest through the opening on the Seat Back. Pinch the Seat
Pad fabric at the corner of the Harness Adjuster Strap Cover. Pull forward on the Seat Pad edge to remove the fabric from
around the Harness Adjuster Strap Cover. Note: The plastic Harness Adjuster Strap Cover is NOT removable.
WARNING - NEVER use Child Restraint without the seat pad.
10
Adjust Head Rest to lowest position and place the seat pad
onto the Carrier shell. Slide fabric opening around the Head Rest
Frame.
15
Adjust the Head Rest to the highest position.
Attaching the Head Rest fabric, start by sliding the
bottom edge of the backplate into the pocket on the back
of the headrest pad. Then carefully pull both Head Rest
side pockets around and over the Headrest frame.
14
Flip the Carrier over and adjust Head Rest into the
lowest position, using the Height Adjuster Plate.
6
Insert the Seat Belt Guides through the side openings on
the fabric.
17
Thread the crotch strap and the Harness Straps
through the correct openings.
16
Fit the fabric opening around the edges of the
Adjuster Strap Cover.
18
TO RE-ATTACH THE FABRIC:
Remove BOTH Shoulder Harness Straps from the
Splitter Plate. Then flip the Carrier upright and pull the
Shoulder Harness Straps to front of Carrier.
7
Remove the Seat Pad from the carrier.
12
Adjust the headrest to the highest position. To remove the Head Rest fabric, pull down on and untuck the bottom
fabric pocket from the Headrest back plate. Then guide the Headrest fabric from each side of the Headrest frame, and
remove the fabric.
13
Slide the fabric over both seat belt guides. Feed
the harness straps, chest clip sections, and crotch buckle
through the fabric openings.
11
Place the Carrier on its side and unhook the Elastic
Straps, located just below the Handle’s rotating hinge.
Then flip out the Plastic Tabs located below the seat belt
guide. Repeat for the other side
8
Height Adjuster
Plate
Adjustment
Positions
Pull the bottom edge of the fabric down and around
the bottom of the Carrier frame working your way to the
top of the carrrier.
19