Chicco KEYFIT BASE - Page 21

21
5
Tighten UAS Belts by pulling up rmly
on UAS Pull Strap while pressing Base
rmly into vehicle seat.
6
Store UAS Pull Strap neatly in Pull
Strap Storage Pocket.
7
Check Installation
a
UAS belts MUST be TIGHT
b
Base MUST be STABLE
c
Bubble MUST be between arrows
d
UAS Pull Strap MUST NOT
interfere with attachment of Carrier
to Base.
8
Attach Carrier to Base after properly
securing infant in Carrier.
2
3
8
5
7
6
1
INSTALLATION USING UAS
ALWAYS lift up on Carrier to
verify it is properly attached to the
Base.
ALWAYS place handle in
LOCKED “CARRY” position when
using Infant restraint system in
vehicle.