6 7
2
Bassinet Assembly
2. Check that the Fitted Sheet is
properly installed on the
Mattress Pad.
Then place the Mattress Pad
into the Bassinet and press it
down flat against the bottom of
the Bassinet.
Note: One side of the
Mattress Pad has a layer of rigid
plastic under the waterproof
material. The rigid plastic layer
goes against the bottom of the
Bassinet.
1A
Bassinet Assembly
1A. Locate both pull straps on
the Extender Bars inside the
Bassinet.
Pull out on both Pull Straps to
lift up the sides of the Bassinet.
1B. Continue pulling on the Pull
Straps until the Extender Bars
lock into place under all four
clips located on the bottom of
the Bassinet, as shown.
Tip: If having trouble
securing the Extender Bar
under the clips, the Pull Strap
can be slid to either side of the
Extender Bar allowing you to
secure one clip at a time.
Double check that ALL
FOUR CLIPS are secured
over the Extender Bars.
1B
To Next Page
Loading...
Need help?
General
