Chicco Presto - Infant Car Seat Installation

14 15
7A. With the Bumper Bar attached
and the Stroller Backrest FULLY
RECLINED, place the Chicco infant
car seat into the Stroller Frame. The
car seat will only fit into the frame
"REAR FACING ONLY". The baby
will be facing you when pushing the
stroller. Make sure infant car seat
clicks into the stroller frame on both
sides.
Note: Pull up on the infant car seat;
make sure it is secured to stroller
frame (7B). If using the Canopy with
the infant car seat rotate the handle
down, to allow the Canopy to fully
extend open.
7B
7A
1
CLICK!
CLIC!
CHECK!
!
VERIFICAR!
2
!
“CLICK!”
8. Squeeze the Release Handle on the
back of the infant car seat and lift up
on the carrying handle, to remove
the infant car seat.
8
Using the Chicco Infant Car Seat Using the Chicco Infant Car Seat