CHMER WIRE CUT- EDM - Introduction of Quick Function Key; Operator Could Apply below Quick Command

CHMER Wire-Cut EDM Operation Manual W5F
1-2-3 Introduction of quick function key
Operator could apply below quick command：
1. Use ＋/－ button to change the value of each item of sparking data.
2. Type S ???
(ex: S045) in Data Bar is to backup current sparking data to
S-code No. 045.
3. Type E ??? (ex: E045) in Data Bar is to call up existing sparking data from
S-code No. 045 for use.
4. To reset Work Coordinate., type R in Data Bar then press ENTER.
5. To specify the value of each axis in Work Coordinate., type X??? Y???
Z??? U??? V??? in Data Bar then press ENTER . ??? is specified value.
6. To move axis incrementally, type MX??? MY??? MZ??? MU??? MV???
In Data Bar and press ENTER. M actually means Move.
7. To move axis by specific Coordinate. System, type M#X??? M#Y???
M#Z??? M#U??? M#V??? in Data Bar and press ENTER. # (0：Machine
Coordinate. / 1：PGM / 2：G92 / 3：Work Coordinate.)
8. To move axis to reference point (G054~G959), type MG#5$X??? Y???
Z??? U??? V???.”# ranges from 0~9, and $ is from 4~9.
9. To move 1/2 distance of what mentioned from 6.~8., type MX/2, MY/2,
MU/2, MV/2.
10. In Data Bar, type GO and press ENTER , machine will move to the zero
points of the coordinate system where the cursor is currently on.
11. To execute N.C program from specific line, type N??? under
MEM\F1(MEM. PATH) when RESET button is lit on.
1-5