CHMER WIRE CUT- EDM - Introduction of Operation Key; Jog; Step Jog

CHMER Wire-Cut EDM Operation Manual W5F
1-2-4 Introduction of operation key
1. JOG
If this button is pressed, four kinds of table moving speed are selectable
including
H (high speed), M (middle speed), ML (speed between middle and
low) and L (low speed). Under this mode, if the axis-moving key is pressed,
the table will move by setting speed. If it is released, the table will stop
moving.
Note: 1. If the JOG button is pressed twice in 1 second, it will execute AUTO
mode.
2. The value of JOG feed-rate override may adjust in the mode Help-2
>「System Double Value Parameter」, PA#36~PA#41 (We strongly
recommend user may not modify the value at will, otherwise it may
cause unexpected damage to machine tool)
2. STEP JOG
If this button is pressed, the table will move by set increment. The set
increments include H (1000µ), M (100µ), ML (10µ) and L (1µ). Under this
mode, if the axis-moving key is pressed one time, the table will move 1
increment distance. If you want 2 increments movement, press the axis-moving
key twice.
1-6