Chord Electronics
TToby | Manual
_
With the unit connected
to a mains power supply,
switch TToby ‘on’ using
the analogue rocker switch
located next to the mains input.
This will switch the unit both on
and o. During the initial start-up
phase, TToby will power-up and
perform a safety check.
Once complete (after
approximately twelve
seconds), the relays will
engage and the output will be
live, with the front LEDs glowing
green.
4.1 Placement
4.2 Connecting TToby to
ancillary equipment
4.3 Line level inputs
4.4 Audio outputs
4.5 Power-on sequence
4.6 Earthing issues in Europe
Power-on sequence 4.5
21 // 23
If a fault is detected the unit will
simply switch itself o. As TToby
consumes very little power when
idle, we recommend leaving the
unit switched ‘on’ when not in
use.
To Next Page
Loading...
