Installation Manual 6838_05
31Troubleshooting |
The appliance does not respond when pressing the start button.
1. Check that the button has been depressed for at least 6 seconds
2. Open the access door under the appliance and confirm that power is available
If the fault persists, contact Christie customer support or your local technician for
assistance, providing details of the fault and the appliance serial number. The CC2 electric
cooktop barbecue has an automatic diagnostic system indicated by green/red flashing of
the START/STOP button.
6.1 Diagnostic codes
Flashing green and red START/STOP button means an error has occurred and the appliance
has entered diagnostics mode. The flashing sequence indicates a particular Fault Code,
confirmed by a seven-second interval and audible “pip” sound. The Fault Code sequence
repeats after a 15-second interval.
A Fault Code corresponding with 1 and 2 in the Troubleshooting Chart below will remain
active until either the power supply is turned off or the fault is repaired. Fault Codes 3 and
4 will result in a 5-minute lockout, after which time the error will still display on the START/
STOP button, but you may be able to restart the appliance. A constant audible “pip” sound
with no flashing lights indicates a low voltage supply.
A Technical Service Manual is available from Christie upon request. This manual contains
detailed information on how to service and repair the appliance, and may be used only by
qualified persons when servicing the appliance.
To Next Page
Loading...