Installing the ultra short
throw lens
The ultr
a short throw (UST) lens allows you to position your projector as close as possible to the
screen.
Affected products
The following products are affected:
• D13HD2-HS
• D13WU2-HS
• D16HD-HS
• D16WU-HS
• D20HD-HS
• D20WU-HS
• Christie 4K7-HS
• Christie 4K10-HS
Required components
The following components are required.
• UST lens bracket kit (P/N: 003-006916-XX)
• 3 mm Allen key
• 5 mm Allen key
• 6 mm Allen key
• Hexagon wrench
Mounting the lens support bracket
The lens holders are replaceable parts marked with an A for the HS Series 2K models and T for the
4K7-HS and 4K10-HS models.
1. Turn on the projector and perform a lens calibration.
• If you have a non-ultra short throw lens (standard lens) installed, perform a lens
calibration by selecting Menu > Configuration > Lens Settings > Lens Calibration.
• If you do not have a non-ultra short throw lens, complete the following steps:
Installing the Ultra Short Throw Lens Instruction Sheet 1
020-103312-03 R
ev. 1 (10-2020)
Copyright
©
2020 Christie Digital Systems USA, Inc. All rights reserved.
To Next Page
Need help?
General
