Digital Power Meter 66201/66202 Quick Start Guide
4
1.6 Time for Warm-Up
All functions of this meter are active when it is powered on; however, to
meet the accuracy listed in the specification it is suggested to warm-up for
at least 60 minutes.
1.7 Cleaning
Ensure all cables and power cords are removed before cleaning the
hardware. Use a dry cloth to clean the chassis. As the rear panel of
power meter connects to the internal circuit board, to avoid damaging the
hardware due to short circuit internally it is not allowed to wipe it with
damp cloth.
To Next Page
Loading...
