To Next PageTo Next Page
Need help?Do you have a question about the Chroma 66200 Series and is the answer not in the manual?
General| Brand | Chroma |
|---|---|
| Model | 66200 Series |
| Category | Measuring Instruments |
| Language | English |
Introduces the 66200 Series Digital Power Meter models and their capabilities.
Guides users on inspecting the instrument for damage after unpacking.
Specifies recommended operating and storage conditions for the meter.
Details how to connect the power cord and select the correct voltage.
Explains the location and replacement procedure for the power fuse.
Recommends a warm-up period for optimal measurement accuracy.
Provides instructions for cleaning the hardware safely.
Lists detailed electrical and physical specifications for the 66201 and 66202 models.
Describes the controls, displays, and indicators on the front panel.
Details the connectors and switches located on the rear panel.
Steps to prepare the instrument before conducting tests.
Instructions for connecting the power meter to test devices or fixtures.
Explains the initial power-on behavior and basic operation modes.
Covers measuring AC voltage, including RMS, peak, and range selection.
Details measuring AC current, including RMS, peak, inrush, and shunt settings.
Explains how to measure active, apparent, and reactive power.
Covers parameters like PF, Crest Factor, THD, and Frequency.
Overview of key functions for setting up measurements.
Configuration for current sampling using shunt resistance.
Enables setting high/low limits for parameter assessment.
Configuration for measurement averaging and windowing.
Setup for inrush current testing, including trigger level and delay.
Explains the automatic fan detection process and error notification.
Introduces GPIB and USB remote control interfaces.
Details hardware, software, and driver installation for USB connection.
Explains how to set the GPIB address using DIP switches.
Describes the GPIB capabilities like Talker/Listener and Service Request.
Covers programming conventions, data formats, and message structures.
Explains command tree structure, headers, and message formats.
Details how to navigate the command tree structure.
Lists and explains standard and instrument-specific SCPI commands.
Lists the pin definitions for the 15-pin D-type terminal for external triggers.
Explains the connection for triggering based on limit conditions.
Details the connection for the Is Trigger (Inrush Current) on model 66202.
Describes connections for TTL signals and Pass/Fail relay outputs.
Explains the connections for Pass and Fail relay outputs.
Provides a high-level block diagram of the power meter's internal structure.
Shows how numbers and letters are displayed on the 7-segment display.
Lists common error messages and their troubleshooting descriptions.
Provides steps to resolve common issues like power failure or data errors.
Lists necessary test equipment and wires for verification.
Step-by-step procedure to verify voltage measurement accuracy.
Step-by-step procedure to verify current measurement accuracy.
Procedure to verify frequency measurement performance.
Steps to verify the accuracy of power measurements.
Lists required test equipment for calibration.
Instructions for connecting test equipment for calibration.
Steps to enter the calibration mode on the instrument.
Procedures for offset, noise, and full-scale voltage calibration.
Procedures for offset, noise, and full-scale current calibration.
Instructions on how to save calibration results.
