To Next PageTo Next Page
Need help?Do you have a question about the Chroma 66202 and is the answer not in the manual?
General| Brand | Chroma |
|---|---|
| Model | 66202 |
| Category | Measuring Instruments |
| Language | English |
Detailed description and labeling of components on the front panel of the power meter.
Description and labeling of the connectors and switches on the rear panel.
Steps to prepare the power meter and environment before conducting tests.
Instructions for connecting the unit under test (UUT) to the power meter.
Overview of the power meter's test functions and operational behavior upon power-up.
How to measure AC voltage (RMS, peak) and understanding voltage range settings.
How to measure AC current (RMS, peak, inrush) and current range selection.
Measuring active power, power factor, apparent power, and reactive power.
Displaying and understanding special parameters like THD, Crest Factor, Frequency, etc.
Introduction to the four main setting functions: Shunt, Limit, Meas, and Is/Trig.
Setting the current shunt module (AUTO, Hi, Lo) for current sampling.
Enabling and setting detection time and high/low limits for various parameters.
Configuring measurement modes (Avg, Windo) and parameters like Energy, Power, Filter, THD.
Setting up Inrush Current Test parameters: trigger level, delay time, and measurement time.
Comprehensive list and description of commands for the power meter.
Commands specific to instrument functions, including Fetch and Measure.
List and description of error messages displayed by the power meter.
Steps to enter the calibration mode on the power meter.
Procedures for offset, noise, and full-scale calibration of voltage measurements.
Procedures for offset, noise, and full-scale calibration of current measurements.
