Chroma 66202 - Page 63

Using Remote Control
Response Parameters: <CRD>, HIGH∣LOW∣AUTO
Header on: :CURRENT:SHUNT<space><CRD><RMT>
Header off: <CRD><RMT>
Example: none
[ SOURce : ] CURRent : RANGe 66201 | 66202
Description: This command sets the current range of measure.
Setting Syntax:
CURRent:RANGe<space><CRD><PMT>
Setting Parameters: <CRD>,
66201: AUTO
∣A2∣A04∣A01∣A001
66202: High shunt: AUTO
∣A20∣A8∣A2H∣A02
Low shunt: AUTO
∣A2L∣A04∣A01∣A001
Auto shunt: AUTO
∣A20∣A8∣A2H∣A02∣A2L∣A04∣A01∣A001
Query Syntax: CURRent:RANGe?<PMT>
Response Parameters: <CRD>,
66201: AUTO
∣A2∣A04∣A01∣A001
66202: AUTO
∣A20∣A8∣A2H∣A02∣A2L∣A04∣A01∣A001
Header on: :CURRENT:RANGE<space><CRD><RMT>
Header off: <CRD><RMT>
Example: none
[ SOURce : ] CURRent : INRush : TRIGger : LEVel 66202
Description: This command sets the level of trigger of inrush current in Ampere.
Setting Syntax:
CURRent:INRush:TRIGger:LEVel<space><NR1><PMT>
Setting Parameters: <NR1>, 1 ~ 10
Query Syntax: CURRent:INRush:TRIGger:LEVel?<PMT>
Response Parameters: <NR1>, 1 ~ 10
Header on: :CURRENT:INRUSH:TRIGGER:LEVEL<space><NR1><RMT>
Header off: <NR1><RMT>
Example: none
[ SOURce : ] CURRent : INRush : TRIGger : TIME 66202
Description: This command sets the time of measure of inrush current in Millisecond.
Setting Syntax:
CURRent:INRush:TRIGger:TIME<space><NR1><PMT>
Setting Parameters: <NR1>, 1 ~ 9999
Query Syntax: CURRent:INRush:TRIGger:TIME?<PMT>
Response Parameters: <NR1>, 1 ~ 9999
Header on: :CURRENT:INRUSH:TRIGGER:TIME<space><NR1><RMT>
Header off: <NR1><RMT>
Example: none
[ SOURce : ] CURRent : INRush : TRIGger : DELay 66202
Description: This command sets the delay of measure of inrush current in Millisecond.
Setting Syntax:
CURRent:INRush:TRIGger:DELay<space><NR1><PMT>
Setting Parameters: <NR1>, 0 ~ 9999
Query Syntax: CURRent:INRush:TRIGger:DELay?<PMT>
5-21