RADIO
REMOVAL
(1) Remove center bezel by pulling straight back
(Fig. 8).
(2) Remove two radio mounting screws (Fig. 9).
(3) Turn OFF radio and ignition switch. DO NOT
disconnect the radio with ignition switch ON.
(4) Pull radio from panel and disconnect wire con-
nectors and antenna lead from radio.
(5) Remove radio.
INSTALLATION
For installation, reverse the above procedure.
REAR QUARTER PANEL SPEAKER
CAUTION: Do not operate the radio with speaker
leads detached. Damage to the output devices may
result.
REMOVAL
(1) Remove rear quarter panel trim grille.
(2) Remove four retaining screws (Fig. 10).
(3) Disconnect wire connector and remove speaker.
INSTALLATION
For installation reverse the above procedure. Be
sure that the wire connectors are facing rearward in
vehicle.
Fig. 8 Center Bezel Removal
Fig. 9 Radio Assembly
MOUNTING SCREWS
Fig. 10 Rear Speakers
SPEAKERGRILLE
JX AUDIO SYSTEM 8F - 17
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
