POWERTRAIN CONTROL MODULE
For Removal/Installation refer to Powertrain Con-
trol Module in Group 14, Fuel Injection System.
VACUUM RESERVOIR
The vacuum reservoir is located on the dash panel
next to the brake booster.
REMOVAL
(1) 2.5L ONLY Remove the intake manifold, refer
to Group 11 Exhaust System and Intake Manifold.
(2) Disconnect vacuum hoses from reservoir.
(3) Pull vacuum reservoir from dash panel.
INSTALLATION
(1) Push reservoir onto dash panel.
(2) Connect hoses to reservoir.
(3) 2.5L ONLY Install intake manifold, refer to
Group 11 Exhaust System and Intake Manifold.
VEHICLE SPEED SENSOR
For Removal/Installation, refer to Vehicle Speed
Sensor in Group 21, Transaxle.
Fig. 12 Disconnecting Throttle Cable—Typical
TABSCABLE
CLASP
JX VEHICLE SPEED CONTROL SYSTEM 8H - 11
REMOVAL AND INSTALLATION (Continued)
To Next Page
Loading...
