Backup Lamp Socket
5. Rotate the backup lamp socket counter clockwise 1/4
turn to remove the backup lamp socket from the trunk
lid lamp housing.
6. Remove the bulb from the socket and install the replace-
ment bulb.
7. Install the backup lamp socket into the trunk lid lamp
housing.
8. Rotate backup lamp socket clockwise 1/4 turn to lock it
into place.
9. Reposition the inner deck panel and secure with a push
pin if removed.
10. Install the access cover.
Stop/Rear Turn Signal Lamp
1. Open the trunk lid.
2. Remove the tail lamp housing beauty cover by grasping
the top edge and pulling rearward to expose the tail
lamp housing bolts.
Tail Lamp Beauty Cover
518 MAINTAINING YOUR VEHICLE
To Next Page
Loading...
