Method of operation
- 92 -
II. Description of remote controller
The remote controller has 8 keys of the same functions as
those of corresponding keys on wire controller. When timing
key is pressed, the unit enters timing status and press ∧ to
change hour setting (increase 1 hour every time this key is
pressed) and press ∨ to change minute setting (increase 15
min every time this key is pressed).
III. Installation of remote controller batteries
① Remove batteries cover in direction shown by the
arrow;
② Fit 2 valid 5# batteries to +/- polarity requirement
in battery chamber;
③ Close batteries cover by pushing upward.
Notes:
(1) Use 2 5#1.5V batteries; do not mix different
batteries;
(2) Remove batteries if the remote controller will not
be used for a long time (>2 months);
(3) Replace batteries when remote control signal is
weak;
(4) Batteries supplied with equipment are valid for 6
months.
IV. Method of operation
(1) Precautions
a. Before startup of air conditioner, connect power to requirements and ensure reliable
earthing.
b. After shutdown of air conditioner, it is necessary to wait at least 3min before restart or
change of operating mode, so as to protect compressor.
c. In normal operating status of air conditioner, shutdown the machine by power ON/OFF key.
To Next Page
Loading...