CIAC CH42A - Page 10

REMOTE CONTROL
Preliminary Instructions
How to insert the batteries
Remove the cover from the battery compartment , by sliding it in
the direction of the arrow
Insert the new batteries, ensuring that the (+) and (-) directions
are
correct
Ret the cover by sliding it into place.
Use 2 AAA (1.5V) batteries . Do not use rechargeable
batteries . Always replace batteries with the same type.
The remote control batteries must be disposed of in accordance
with local codes and regulations.
BE CAREFUL:if you adjust the remote control in cooling mode,
it will not be possible to activate the heating function in units with
heating pump . you need to take out the batteries and repeat again
the procedure described above.
1. Direct the remote control toward the conditioner.
2. Check that there are no objects between the remote control
and the receiver on the conditioner.
3. Never leave the remote control exposed to the sun.
4. Keep the remote control at a distance of at least 1m from the
television or other electrical appliances.
Recommendations for locating and using the remote control (if present)
The remote control may be kept in a wall-mounted holder
S ignal
receptor
Refer to picture 2:
When you insert the batteries for the rst time in the remote
control or if you change them, you need to program the remote
control of cooling only or heat pump air conditioners.
As soon as you insert the batteries, the symbols
( ) and ( ) starts fashing. If you push
any button when the symbol ( ) is displayed,the
remote control is adjusted in only cooling mode . If you push
any button when the symbol is displayed ,
the remote control is adjusted in heating mode.
8
COOL
HEAT
(COOL
( HEAT )
DRY
FAN
HEAT
TIME R
HEALTHY
AIR
SWING
FAN
SPEED
COOL
FEEL
DRY
FAN
HEAT
TIME R
HEALTHY
AIR
SWING
FAN
SPEED
COOL
F E EL
Refer to picture 1:
i. When you insert the batteries for the rst time in the remote
control or if you change them,you will see a DIP switch under
the back cover.
ii. BE CAREFUL: After adjusting the function, you need to remove
the batteries and repeat the procedure described above.
+
+
+
DIP switch on position Function
The display is adjusted in degree celsius
The remote control is adjusted in only cooling mode
The remote control is adjusted in only heating mode
The display is adjusted in degree fahrenheit.
DIS
PL
AY
HE
AL
THY
3D
O
N
/OF
F
SWIN
G
FAN
TI
MER
SU
PE
R
SL
EE
P
M
OD
E
EC
O
CL
OC
K
R emote controller holder
DISPLAY
HEALTH Y
3D
ON/OFF
SWING
FAN
TIMER
SUP ER
SLE
E
P
MODE
ECO
CLOCK
DISPLAY
HEALTH Y3D
ON/OFF
SWING
FAN
TIMER
SUP ER
SLE E P
MO
DE
ECO
CLO
CK
Cool
Heat
C
F