CiBest M18 - Adjust Image Projection; Startup & Shutdown

3
Adjust the image projected
Check the horizontal and vertical settings of
AB CD
AB CD

4
Startup & Shutdown
Installation and debugging
How to quickly install and debug the projector
onto the screen
the screen
！
Precaution
1. When the screen is offset to the left or right, move the projector to
one side. (Center the screen at the center of the projector lens).
2. When shifting in a vertical direction, move the projector up or down.
3. If there is an angular offset, place the projector on a horizontal
plane.
4. If the projection screen is as shown in the figure, it indicates that the
projector does not face the screen directly. Please turn the projector
to face the screen.
When the projector is suspended
from the ceiling or in a rear
projection system, please chan
ge
the projection direction in the
settings (See Projector settings on
page 14 to change the projection
direction).
1. 5 seconds after power-on, press the key (POWER) on the
projector panel or the remote controller to turn on the device.
2. Press the key
(POWER) on the projector control panel or the
remote control to turn off the device as prompted by the system.
When the machine is turned off, unplug the power line in time to
save energy.
8

2

1


3
3


4
4