◄
►
Images
Image modes
Color temperature
Scaling pattern
Noise reduction
Projection direction
Screen reduction
Image settings
Projector settings
Start to use
Properly set up the projector for better film experience. Main
parameters of projection can be set up through the following steps.
1. Open the video page and press “MENU” on the projector
panel or remote control to the interface as shown below.
Image modes: Preset “standard”, “dynamic”, “soft”, “user defined”
and other image modes for different projected
contents.
Color temperature: Preset “standard”, “warm” and other color temperature
modes for different color preferences.
Scaling pattern: Preset “automatch”, “16:9”, “4:3” and other options for th
e
adjustment of display scale.
Noise reduction: To set up the intensity of noise reduction.
Projection direction: To set up the direction of image display. Suitable for
adjusting image display directions for projectors
mounted by different means.
Screen reduction: To proportionally reduce the screen scale, ranging from
75% to 100%.
2. Press “ ”“ ” on the projector panel or remote
control, choose between different options and press
“OK” to submenu and properly set up the mode.
14
To Next Page
Loading...