3
Vanity Unit Type A
Drawer Removal/Replacement (Blumotion
™
Drawer System)
1 To remove drawer from the vanity,
open the drawer to halfway.
2 Locate the orange locking devices
underneath the drawer (on both sides).
3 Squeeze the orange levers and pull
the drawer forward i.e. away from
the vanity. The drawer should have
released the runners. Pull the drawer
up towards you and continue to
extract the drawer from the unit.
4 Once the drawer has been removed,
push the runners back into the unit to
avoid damaging the runners.
To ensure that debris does not
fall into the runner mechanism
during drilling etc. cover runners
with bubble wrap or plastic.
5 To reinstall the drawer into the unit
pull runners out of the unit and
simply place the drawer on the
runners and close. The locking
devices automatically engage (you
should hear them click) and self-
align when the drawer is installed
Blumotion™ drawer runner - Type A
It’s vital that the runners
are covered during the
installation process as debris
may cause the runners to
malfunction.
To Next Page
Loading...