What’s Included Vehicle Sensor Installation
54
ShifterPro Interface
Wiring Harness
Two (2) ShifterPro Sensors
Hardware Accessories
Important!
Plan your installation carefully. It is highly
advisable to inspect the entry points from
the engine compartment into the driver’s
cabin before installation of sensors. For
optional rear sensor installation, look for
entry points behind the license plate or
lights.
If you are unable to find entry points, you
will need to drill a hole at least 0.2 in (5
mm) in diameter to route the cable into
the cabin. (If installation is performed
by a professional, consult with your
customer before drilling any holes.)
Apply rubbing alcohol if needed, so
you can easily pull cable into the
cabin without damaging it.
After installation is complete, use
cable ties to fasten sensor cables to a
solid surface, keeping them away
from heat and any moving parts.
To Next Page
Loading...