6
8200 Series Mobile Computer Reference Manual
INSTALLING PISTOL GRIP
This contoured pistol grip enables intuitive trigger-and-scan operation, which is very
helpful in scan intensive applications.
When a pistol grip is necessary, install it to the Terminal by following these steps:
1) Hold the Terminal still and slide the release latch to the right to unlock the battery
cover.
2) Slide off the battery cover.
3) Insert the pistol grip into place (is like replacing the battery cover).
4) Slide the release latch to the left to lock it firmly, and turn on the Terminal to test the
trigger.
Figure 3: Installing the Pistol Grip
To Next Page
Loading...
