2.4. NOTIFICATIONS
2.4.1. STATUS LED
Two LED indicators located above the touch screen provide information about charging
status, scanner light beam, and scanner "Good Read" during data collection.
LED 1 for Power Indication
Charging the mobile computer (0% to 99%)
Charging temperature error
(lower than 0 or exceed 45 )
Pressing power button and select “Battery Swap” in the
pop-up menu, and the red status LED lights up. As the red
light goes off, the device is in complete suspend mode and
Main battery is ready to be replaced
LED 2 for Reader & System Notification
Note:
For Scanner decode and Scanner beam LED to function, LED notification must be enabled in Reader
Configuration.
To Next Page
Loading...
Need help?
General
