95
Customize Project Configuration
Addon Redundancy
Functions when “auto-discriminate” is applied for UPC/EAN addons.
Decides the number of times of supplemental decoding of the same
barcode in order to count as a valid read.
Level
Users can adjust the illumination brightness of the LED light source.
Sets whether to include AIM code ID character in the decoded data.
Data Output allows users to set the way to output decoded data. Depends on the reader
module, the available functions may be slightly different.
Keyboard Emulation setting controls which way the data is sent.
Timeout between
Input Method
To specify the pause time between data to be transmitted.
The function is only available when “Keyboard Emulation” is set to
be “Input Method”.
Auto Enter
To add an ENTER character before or after each string of decoded
data. The ENTER character can be defined in the “Auto Enter
character” field below. This function saves the trouble of pressing a
confirmation key to accept each string of decoded data.
Auto Enter character
To add a key code before or after the decoded data. If [Auto Enter] is
enabled, select the ENTER character to send.
To prefix the output data with code type information.
Display Code Length To suffix the output data with code length information.
Prefix
To affix 0 to 20 characters to the left of the output data. Click on the
button “Open ASCII Table ” to open a character table for
entering the prefix.
Suffix
To affix 0 to 20 characters to the right of the output data. Click on the
button “Open ASCII Table ” to open a character table for
entering the suffix.
Field Delimiter
Sets the delimiter to separate the output barcode data as the
following pieces: code type, decoded barcode data, and code length
(if applicable).
To Next Page
Loading...
Need help?
General
