CIPU CSPPD704 - Pump Operation and Maintenance; Two-Speed Pump Usage; Strainer Basket Maintenance

ENSURE
that all suction and discharge valves are open before you start the pump, otherwise
will result in damage to the pump.
Two-Speed Pumps
Two-
speed models are recommended in a swimming pool when high speed is needed for
maximum filtration at peak periods and whenever turbidity levels are high. At other times,
switch to low speed. For backwashing and vacuu
tubs, use high speed to attain full performance in the hydro
as filter/heat cycle mode, use low speed. Low speed provides sufficient flow to activate most
spa heaters and provides s
ufficient flow for filtration.
performance in the hydro-
therapy mode and use low speed mode to prime. The below
shows
the positions of high speed and low speed.
Maintenance
The strainer basket in the filter tank should be inspected and cleaned at
1. Remove lid and lift out basket.
2. Remove debris and hose off with clean water if necessary.
3. Inspect the lid gasket, lubricate with
only if needed. If it is damaged, pls replace.
4. Replace the strainer.
5. Re-prime the filter tank.
6. Correctly locate the o-ring.
7. Replace the lid hand tighten
only.
8. Switch on pump.
that all suction and discharge valves are open before you start the pump, otherwise
speed models are recommended in a swimming pool when high speed is needed for
maximum filtration at peak periods and whenever turbidity levels are high. At other times,
switch to low speed. For backwashing and vacuu
ming, high speed is required. In spas and hot
tubs, use high speed to attain full performance in the hydro
-
therapy mode. At other times, such
as filter/heat cycle mode, use low speed. Low speed provides sufficient flow to activate most
ufficient flow for filtration.
In jetted tubs, use high speed to attain full
therapy mode and use low speed mode to prime. The below
the positions of high speed and low speed.
The strainer basket in the filter tank should be inspected and cleaned at
regular intervals.
2. Remove debris and hose off with clean water if necessary.
3. Inspect the lid gasket, lubricate with
silicon based grease
only if needed. If it is damaged, pls replace.
only.
that all suction and discharge valves are open before you start the pump, otherwise
speed models are recommended in a swimming pool when high speed is needed for
maximum filtration at peak periods and whenever turbidity levels are high. At other times,
ming, high speed is required. In spas and hot
therapy mode. At other times, such
as filter/heat cycle mode, use low speed. Low speed provides sufficient flow to activate most
In jetted tubs, use high speed to attain full
therapy mode and use low speed mode to prime. The below
figure
regular intervals.
5