• Disable Spanning Tree Protocol (STP) on any third-party switching equipment connected to the device's
management interface.
Procedure
Step 1 Choose System > Configuration.
Step 2 Choose Console Configuration.
Step 3 Select a remote console access option:
• Choose VGA to use the appliance’s VGA port. (This is the default.)
• Choose Physical Serial Port to use the appliance’s serial port.
Step 4 Click Save.
Use the Shell to Redirect the Console Output
Before you begin
Complete the initial setup process appropriate to your version:
• For Versions 6.5 and later see Install the Management Center for Versions 6.5 and Later, on page 6.
• For Versions 6.3 - 6.4 see Install the Management Center for Software Versions 6.3 - 6.4, on page 19.
Procedure
Step 1 Use the management center CLI admin credentials to access the Linux shell on the management center using
the method apppropriate to your version; see Access the CLI or the Linux Shell on the Management Center,
on page 5.
Step 2 At the prompt, set the console output by entering one of the following commands:
• To direct console messages to the VGA port: sudo /usr/local/sf/bin/configure_console.sh vga
• To direct console messages to the physical serial port: sudo /usr/local/sf/bin/configure_console.sh
serial
Step 3 To implement your changes, reboot the appliance by entering sudo reboot.
Preconfigure Management Centers
You can preconfigure your management center at a staging location (a central location to preconfigure or
stage multiple appliances) to be deployed at a target location (any locatiaon other than the staging location).
To preconfigure and deploy an appliance to a target location, perform the following steps:
1. Install the system on the device at the staging location.
Cisco Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
45
Firepower Management Center 1600, 2600, and 4600 Getting Started Guide
Use the Shell to Redirect the Console Output
To Next Page
Loading...
