EasyManua.ls Logo

Cisco 1841 - Verifying the Hardware Configuration; Initial Configuration of the Router

Cisco 1841
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7-5
Cisco 1800 Series Routers (Modular) Hardware Installation Guide
OL-5876-03
Chapter 7 Power-Up Procedures for Cisco 1800 Series Routers (Modular)
Verifying the Hardware Configuration
Figure 7-1 LEDs on the Front Panel of the Cisco 1861 Integrated Services Router
Verifying the Hardware Configuration
Verify the router hardware configuration by using the following commands:
show version—Displays the system hardware version, the installed software version, the names and
sources of configuration files, the boot images, and the amount of installed DRAM and flash
memory.
show diag—Lists and displays diagnostic information about the installed controllers and interface
processors. Typical examples are interface cards (VWICs, WICs, HWICs), and advanced integration
modules (AIMs).
Initial Configuration of the Router
This section covers the following topics:
Initial Configuration, page 7-5
Verifying the Initial Configuration, page 7-6
Completing the Configuration, page 7-6
Initial Configuration
You can configure your router by using one of the following tools:
1 SYS Solid green Online
2 POE Solid green Connected
3 VM Solid green Online
4 WLAN Blinking green Connected
230870
1
SYS
POE
VM
WLAN
4
3
2
1

Other manuals for Cisco 1841

Related product manuals