EasyManuals Logo

Cisco 2505 User Manual

Cisco 2505
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
34
Step 2 The CLI displays the root level system prompt:
#(system prompt)>
The system prompt can be any alphanumeric string up to 31 characters. You can change it by
entering the config prompt command. For example, to change the system prompt to
CISCO2504, enter config prompt "CISCO2504" and press Enter. Make sure you enter the
new prompt using double quotation marks.
Note The CLI automatically logs out without saving any changes after 5 minutes of
inactivity. You can set the automatic logout from 0 (never log out) to 160 minutes
using the config serial timeout command.
6 Connecting to the Network
Figure 13 shows the connection from the network (802.11 distribution system) to the controller. The
connection uses 10/100/1000BASE-T Ethernet (RJ-45 physical port, UTP, Category-5 or higher cable).
Always use Category-5, Category-5e, Category-6, or Category-7 Ethernet cables to connect the office
network equipment to the controller.
Figure 13 External Network Equipment Connection to the Controller
282298
Network
Firewall
C
onnection to
main office
10/100/1000BASE-T
MDI cable
CLI console
Cisco
Access Poin
ts
10/100/1000BASE-T
MDI cable
Office
network

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 2505 and is the answer not in the manual?

Cisco 2505 Specifications

General IconGeneral
BrandCisco
Model2505
CategoryController
LanguageEnglish

Related product manuals