EasyManuals Logo

Cisco 3700 User Manual

Cisco 3700
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #7 background imageLoading...
Page #7 background image
1-7
Cisco 3700 Series Routers Hardware Installation Guide
OL-2180-08
Chapter 1 Overview of Cisco 3700 Series Routers
Interface Numbering
Cisco 3745 Interfaces
Each individual interface (port) on a Cisco 3745 router is identified by number as described in the
following sections.
WAN and LAN Interface Numbering
The Cisco 3745 router chassis contains the following WAN and LAN interface types:
Two built-in FastEthernet LAN interfaces
Three slots in which you can install WAN or voice interface cards
Four network module slots
The numbering format is interface-type slot-number/interface-number. Two examples are:
FastEthernet 0/0
Serial 1/2
The slot numbers are as follows:
0 for all built-in interfaces
0 for all WIC interfaces
1 for the lower-right network module slot
2 for the lower-left network module slot
3 for the upper-right network module slot
4 for the upper-left network module slot
If double-wide network modules are installed, the network module slots are numbered as follows:
2 for the lower double-wide slot
4 for the upper double-wide slot
Interface (port) numbers begin at 0 for each interface type, and continue from right to left and from
bottom to top.
Figure 1-4 shows the rear panel of the Cisco 3745 with:
A WIC in each of the three WAN interface card slots
A single-wide network module in each of the four network module slots
Two AC power supplies
The slot number for all WIC interfaces is always 0. (The W0, W1, and W2 slot designations are for
physical slot identification only.) Interfaces in the WICs are numbered from right to left, starting with
0/0 for each interface type, regardless of which physical slot the WICs are installed in. Some examples
are:
If physical slot W0 is empty and physical slot W1 contains a 1-port serial WIC, the serial interface in
the WIC is numbered Serial 0/0.
If slot W0 contains a 2-port serial WIC and slot W1 contains a 1-port serial WIC, the serial interfaces in
physical slot W0 are numbered Serial 0/0 and Serial 0/1, and the serial interface in physical slot W1 is
numbered Serial 0/2.
If slot W0 contains a 2-port serial WIC and slot W1 contains a 1-port BRI WIC, the serial interfaces in
physical slot W0 are numbered Serial 0/0 and Serial 0/1, and the BRI interface in physical slot W1 is
numbered BRI 0/0.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 3700 and is the answer not in the manual?

Cisco 3700 Specifications

General IconGeneral
Routing ProtocolsBGP, OSPF, EIGRP, RIP, IS-IS
Connectivity TechnologyWired
Remote Management ProtocolSNMP, Telnet, SSH, HTTP, HTTPS
Operating SystemCisco IOS
InterfacesVaries by module
PerformanceVaries by configuration
Security FeaturesFirewall, VPN, ACLs, IPS
Product TypeRouter
Data Link ProtocolEthernet, Fast Ethernet, Gigabit Ethernet
Network/Transport ProtocolTCP/IP, UDP
FeaturesQoS
Router TypeModular
WAN InterfacesVaries by module
LAN InterfacesEthernet, Fast Ethernet, Gigabit Ethernet
ProcessorVaries by model
MemoryVaries by model
Flash MemoryVaries by model
DimensionsVaries by model
WeightVaries by model
Form FactorRack-mountable
Power SupplyInternal AC power supply, optional redundant power supply

Related product manuals