EasyManua.ls Logo

Cisco 4948 - Catalyst Switch - Page 94

Cisco 4948 - Catalyst Switch
162 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
B-4
Catalyst 4948E an Catalyst 4948E-F Switch Installation Guide
OL-21561-02
Appendix B Transceiver, Chassis Connectors, and Cable and Adapter Specifications
Transceiver Support for Uplink Ports
Table B-2 lists the specifications for the 1000BASE-T and 1000BASE-X SFP transceivers.
Ta b l e B-2 1000BASE-T and 1000BASE-X SFP Transceiver Specifications
SFP Transceiver
Module and Product
Number
Interface
Connector
Nominal
Wavelength
(nm)
Network
Cable Type
Fiber Core
Size
(micron)
Modal
Bandwidth
(MHz/km)
Cable Distance
1
1. Cable distances are based on fiber loss. Additional factors, such as the number of splices and the optical quality of the fiber, can affect cabling
distances.
1000BASE-T
(GLC-T=)
RJ-45 Category 5,
5e, or 6
UTP/FTP
328 ft (100 m)
1000BASE-SX
(GLC-SX-MM=)
LC duplex 850 MMF 62.5
62.5
50.0
50.0
160
200
400
500
722 ft (220 m)
902 ft (275 m)
1640 ft (500 m)
1804 ft (550 m)
1000BASE-LX/LH
(GLC-LH-SM=)
LC duplex 1300 MMF
2
SMF
2. A mode-conditioning patch cord is required. Using an ordinary patch cord with MMF, 1000BASE-LX/LH SFP transceivers, and a short link distance
can cause transceiver saturation, resulting in an elevated bit error rate (BER). When using the LX/LH SFP transceiver with 62.5-micron diameter
MMF, you must also install a mode-conditioning patch cord between the SFP transceiver and the MMF cable on both the sending and receiving ends
of the link. The mode-conditioning patch cord is required for link distances greater than 984 ft (300 m).
62.5
50.0
50.0
G.652
3
3. ITU-T G.652 SMF as specified by the IEEE 802.3z standard.
500
400
500
1804 ft (550 m)
1804 ft (550 m)
1804 ft (550 m)
6.21 mi (10 km)
1000BASE-ZX
(GLC-ZX-SM=)
LC duplex 1550 SMF G.652
3
43.4 to 62 mi (70 to
100 km)
4
4. 1000BASE-ZX SFP modules can reach up to 62 miles (100 km) by using dispersion-shifted SMF or low-attenuation SMF; the actual distance depends
on the fiber quality, the number of splices, and the connectors.
1000BASE-BX10
(GLC-BX-D=)
LC single 1490
(downstream)
SMF G.652
3
6.21 mi (10 km)
1000BASE-BX10
(GLC-BX-U=)
LC single 1310
(upstream)
SMF G.652
3
6.21 mi (10 km)

Table of Contents

Related product manuals