Cisco 7000 - Page 19

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions 19
Installation
Figure 11 Positioning and Fastening a Spanner Bar
Caution
To ensure adequate space between the brackets and a proper chassis fit, push the brackets
as far apart as possible before tightening the screws that secure them and the spanner bars.
Step 5 When both spanner bars are in place, use a number 2 Phillips screwdriver to tighten the six
pan-head screws that secure the brackets to the rack-mounting posts, and the two anchor
screws that secure the spanner bars. When tightening the pan-head screws on a bracket,
push the bracket outward, away from the center of the rack, to ensure that the brackets
remain at least 17.5 inches apart (otherwise the chassis will not fit between the brackets).
This completes the bracket installation. To install the ears on the chassis, proceed to the next section.
H2294
a
c
b