Cisco Business Edition 7000 - User Manual

Installation
•
Power On and Initial Setup, page 1
•
Customize Hypervisor for Remote Access, page 3
•
Access and Configure Hypervisor, page 7
•
Using Predeployed Virtual Machines, page 12
•
Deploy New Virtual Machines , page 12
•
Install Applications on Virtual Machines, page 13
Power On and Initial Setup
Procedure
Step 1
Verify that the monitor and keyboard are connected as described in the Quick Start Guide.
Step 2
Power on the monitor.
Step 3
Verify that power is connected and the Power LED status, as shown in Figure 1: Power and LED Status -
BE7000M Server, on page 1 and Figure 2: Power and LED Status - BE7000H Server, on page 2.
Figure 1: Power and LED Status - BE7000M Server
If the status of the Power LED is orange, that indicates server is off. If it is not, check the electrical and network
connections. If the status of the Power LED is green, skip forward to step 5.
Cisco Business Edition 7000 Installation Guide, Release 11.6
1

Cisco Business Edition 7000 Specifications

General

Model	Cisco Business Edition 7000
Hard Drives	SAS, SATA, SSD
RAID Support	RAID 0, 1, 5, 6, 10
Power Supply	Redundant hot-swappable power supplies
Processors	Intel Xeon E5-2600 series

Summary

Power On and Initial Setup

Customize Hypervisor for Remote Access

Access and Configure Hypervisor

Preloaded Files on Datastore

Explains ISO and OVA file types used for collaboration applications.

Using Predeployed Virtual Machines

Deploy New Virtual Machines

Install Applications on Virtual Machines