To Next PageTo Next Page
Need help?Do you have a question about the Cisco UCS B200 M5 and is the answer not in the manual?
General| Form Factor | Blade |
|---|---|
| Processor | Intel Xeon Scalable Processors |
| Management | Cisco UCS Manager |
| Processor Sockets | 2 |
| Product Type | Blade Server |
| Memory | Up to 3 TB DDR4 |
| Memory Slots | 24 DIMM slots |
| Storage | Up to 2 x SAS/SATA drives |
| Expansion Slots | Mezzanine card |
| RAID Support | RAID 0, 1 |
| Network | 10 Gigabit Ethernet, 25 Gigabit Ethernet |
| Power Supply | Part of UCS Blade Server Chassis |
Introduces the Cisco UCS B200 M5, a density-optimized, half-width blade server with dual CPU sockets.
Provides step-by-step instructions for installing a half-width blade server into a UCS chassis.
Explains that Cisco UCS blade servers should be configured and managed using Cisco UCS Manager.
Details the procedure for safely powering off a blade server, including graceful shutdown and using Cisco UCS Manager.
Outlines the steps to decommission and physically remove a blade server from the chassis using UCS Manager.
Describes how to replace SAS, SATA, or NVMe drives in the front storage mezzanine module.
Explains the POST diagnostics, LED states, and how to use the LED diagnostics button for component identification.
Details the procedure for installing the front mezzanine storage module for drive bays and RAID controller support.
Provides detailed steps for removing and installing CPUs and their associated heatsinks, including tools and precautions.
Gives step-by-step instructions for installing memory modules (DIMMs) or DIMM blanks into server slots.
Guides on installing TPM hardware and enabling TPM support and TXT support in the server BIOS via UCS Manager.
Outlines the sequence for updating server BIOS, activating firmware, and installing NVIDIA drivers for GPU cards.
