Cisco UCS B200 M5

CHAPTER 2
Installing a Blade Server
This chapter contains the following sections:
•
Installing a Half-width Blade Server, page 7
•
Server Configuration, page 9
•
Powering Off a Blade Server, page 9
•
Removing a Blade Server, page 9
•
Server Troubleshooting, page 10
Installing a Half-width Blade Server
The Cisco UCS B200 M5 blade server and other half-width blade servers are interoperable in a UCS chassis
with any other UCS blade servers. To install a half-width blade server, follow these steps:
Before You Begin
The blade server must have its cover installed before installing it into the chassis to ensure adequate airflow.
Cisco UCS B200 M5 Blade Server Installation and Service Note
7